October 3, 2006

The work tonight was more in my head than in actual progress towards getting the compressor piped to the shop. I need to connect the compressor from the 3/4" outlet shown in the picture above, through the finish room wall, attach it to the pressure regulator (on the left in the picture below) and the filter and air dryer unit. From the right side of the assembly in the picture below I need to provide an air outlet for the finish room and then exit back through the finish room wall to connect to the air line running to the table saw and one for the garage area. This will take a lot of thought, planning, and it appears lots of fittings.

Current Project Page

Main Page

Next Page